Calendar

June 2017
SunMonTueWedThuFriSat
 << < > >>
    123
45678910
11121314151617
18192021222324
252627282930 

Announce

Who's Online?

Member: 0
Visitors: 8

rss Syndication

Apr252017

04:45:36 pm

Sauer Danfoss (Turolla) Gear Pumps

Overview Of Jacking Oil System

Earlier than backpacking the Appalachian Trail (<-my journal), I might completed loads of mountaineering, however the majority of those trips had lasted a day or two at most. After engagement, managed by a limit swap, the total stress from the turning gear pump is provided to the radial piston motor turning the shaft with full turning gear speed. Two solenoid valves, one for creep pace and the opposite for full velocity, management the turning gear oil supply. The turning gear pump and the jacking oil pump are pushed by one frequent AC motor.

Turolla OCG excessive efficiency gear pumps are mounted displacement pumps which include the pump housing, drive gear, pushed gear, DU bushings, rear cowl and entrance flange, shaft seal and inside/outer seals. In case you fill the gearbox from the top gap, except you are VERY LUCKY you'll get an air lock within the gearbox, this will be an enormous bubble of air that takes up the house required for the gear oil to fill.

The jacking oil system and the turning gear system belong to the same function group controller. Turning gear operation with out jacking oil switched on is just not allowed, because the bearings might be broken as a consequence of insufficient lubrication. Case of an emergency the turning gear system could also be switched-off for a maximum of 15 minutes after sooner or later and half-hour after 2 days steam turbine shut-down. Examples shown are group 3 gear pump collection SNP3/SNP3NN (on the left) and group 2 gear pump series SNP2/SNP2NN (on the correct). The stress balanced design of the pumps gives high efficiency for the whole collection.

Engage the drive pinion, a solenoid valve is activated, which exerts lube oil stress on the piston of the drive pinion. At the similar time, creep pace operation of the radial piston motor is began by the drive from the strain Tu decreased oil from the turning gear pump to guarantee engagement of the drive pinion. Then the engagement solenoid valve is switched off, the turning gear remains engaged by the constructive torque of hydraulic motor.

So, if you are searching for efficient submersible pumps , water pumps and other pumps in Australia, then it is best to hire reliable pump providers. Pump Options Australasia are importers and distributors of high quality European pumps and filters. Jacking oil system protects the turbines journal bearings during begin-up and shut-down. Turning gear system rotates the turbine shaft so that it will not bend, because of uneven temperature distribution. Turning gear pump is an axial piston sort, which is situated on the lube oil tank.

Admin · 382 views · Leave a comment

Permanent link to full entry

http://handscars3609.sosblogs.com/The-first-blog-b1/Sauer-Danfoss-Turolla-Gear-Pumps-b1-p482.htm

Comments

No Comment for this post yet...


Leave a comment

New feedback status: Published





Your URL will be displayed.


Please enter the code written in the picture.


Comment text

Options
   (Set cookies for name, e-mail and url)